Enter a search term
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

3D20 nozzle unclog pin diameter

Transistor
New Contributor

a week ago

I've mislaid the nozzle on a borrowed 3D20. I have wire, a bending jig and an online photo of the pin.

  1. Can anyone check the pin diameter for me?
  2. Is it supposed to pass through the 0.4 mm nozzle? (Obviously not, if it's bigger than the nozzle.)

Many thanks.

0 Kudos
1 REPLY 1

DremelJohn
Community Manager
Community Manager

a week ago

Hi Transistor,

I sit next to the Dremel 3D customer service team and ran your question past them. Their reply is that we never recommend putting a pin or anything through the nozzle tip, if you have a clog we have a special tool to push through the assembly and or motor but not the nozzle tip. Your best bet is to contact the Dremel 3D support team direct at (844) 437-6533. 

0 Kudos