3D20 nozzle unclog pin diameter

[Transistor]

I've mislaid the nozzle on a borrowed 3D20. I have wire, a bending jig and an online photo of the pin.

1. Can anyone check the pin diameter for me?
2. Is it supposed to pass through the 0.4 mm nozzle? (Obviously not, if it's bigger than the nozzle.)

Many thanks.

[DremelJohn]

Hi Transistor,

I sit next to the Dremel 3D customer service team and ran your question past them. Their reply is that we never recommend putting a pin or anything through the nozzle tip, if you have a clog we have a special tool to push through the assembly and or motor but not the nozzle tip. Your best bet is to contact the Dremel 3D support team direct at (844) 437-6533.